Emtec AVDH-1 Guia do Utilizador

CommissioningGuideForEMtechAVDH‐1andAVDH‐2Version 0.9b – 21 February 2013 CertificationRequirementsThis commissioning guide is intended for M

AND THE RACK TV MONITOR. RETURN ALL CABLES TO THE KIT AND PLACE IT BACK IN THE SATELLITE RACK

VerifyingAudioandAdjustingLevelsAdjustingChapelAudioInputLevel(AVDH‐1Only)1. In Chapel, turn on audio system 2. In Chapel, connect an au

 SetAVDH‐1toEncoderoutputlevel:1. Disconnect rear panel audio output #4 and #6 (check cables for proper labeling before disconnection) 2. Con

a. In Chapel, turn on the audio system and adjust audio level ¾ of maximum b. Enable Satellite audio feed switch and turn satellite audio to ¾ of ma

4. Rotate Source selector on AVDH-1 front panel to the Camera position 5. Tune rack TV monitor to primary language channel (the installed camera in

13. Continue to turn AUX audio input volume down slightly below the distortion level (e.g. 1/16th turn) 14. Adjust rack TV monitor volume to comfortab

a. You must enter a 15 digit number (e.g. 000000000055555) followed by a “-“, then a 6 digit number (e.g. 666666), then a “-“, followed by “00”. b.

b. Use up and down arrow keys to select digits (enter a valid Stake, Ward, or Branch Unit ID. If unknown enter a temporary six digit number that wil

verify installation compliance and quality. This information is recorded to aid support personnel. To certify the installation (or request the curren